Unit installation

Q3007 Biometric Transponder
Page 5
2.3 How the transponder works
You can interrupt the action in each mode by pressing the button briefly to change to
Standby.
2.4 "Learn" state: start-up, scanning in fingerprints
Initial start-up - scanning in the first 2 fingerprints (Administrator fingerprints)
To start the Q3007, two "Administrator fingerprints" need to be scanned in first of all.
We recommend that a fingerprint from the left and right hand of one person, the
administrator (e.g. safety officer) is used for this. However, you can also use one
finger from two different people.
Stand-by mode: LED not illuminated
Briefly press button once, then release
Recognise mode: LED flashes green
Learn mode: LED flashes yello
w
Delete state: LED flashes red
Drag finger across sensor
Transponder triggered
Press button and hold
down for 3 sec.
New finger is memorised
Press button and hold
down for 3 sec.
Drag Administrator finger
once over sensor and new
finger (User finger) 3 times
over sensor.
Draw user finger once
across sensor
Draw Administrator finger
once across sensor
All fingerprints are deleted
Only user fingerprint is
deleted