Unit installation

Q3007 Biometric Transponder
Page 4
2.0 Overview of function
2.1 Basic information on operation
The Biometric Transponder Q3007 scans fingerprints using a fingerprint sensor. The
finger is dragged across the sensor, rather than being pressed against it.
The following should be noted:
The fingerprint to be scanned/ memorised should always be dragged over the sensor
in the same way.
To do this, place the tip of the finger that is to be stored or to be recognised at the
upper edge of the Biometric Transponder and draw it across the sensor from top to
bottom (towards the button) at a constant speed whilst applying slight pressure. The
design of the housing means that the finger is guided properly through the slightly
raised side walls. This more or less excludes the possibility of using the transponder
incorrectly.
The fingerprint sensor can thus pick up the fingerprint line by line and reassemble it
into a complete image in the integrated processor. If the reassembled image matches
the saved image, the Transponder is released.
2.2 Operating states
The Q3007 has four different operating modes:
Mode Function
Standby
The Q3007 is normally on "Standby" in order to save the battery
capacity. After it has completed a function (e.g. scanning), it
always returns to the standby mode.
Learn
In the "Learn" mode, new fingerprints can be memorised. Up to 6
different fingerprints can be saved, two of which are what we call
"administrator" fingerprints. New fingerprints (user fingerprints)
can only be scanned in with the help of an administrator. The
only exception is the scanning of the first two fingerprints
(Administrator fingerprints), see below
Delete
In the "Delete" mode, fingerprints that have been memorised can
be deleted. Individual prints can be deleted, or all fingerprints can
be deleted at once.
Recognise
The "Recognise" mode is the mode before a door is opened. In
this mode, the Transponder is released if a fingerprint is correctly
recognised.