Unit installation

Q3007 Biometric Transponder
Page 3
1.0 General Instructions
Please take 15 minutes to familiarise yourself with how your Biometric Transponder
Q3007 works with the help of these operating instructions.
1.1 Safety instructions
Caution! – The batteries used in this product could burn or cause a fire if they are not
handled properly. Do not charge, open or burn these batteries or heat to over 100°C.
Make sure that the sensor surface is not dirty or scratched. Do not drop the Q3007 or
expose it to any other strong impacts.
In addition, please make sure that the initial scanning in of fingerprints is not carried
out by unauthorised persons!
We advise you to protect the Q3007 against unauthorised access if possible.
Handling a Q3007 assumes knowledge of how to use SimonsVoss software.
Programming should therefore only be carried out by trained specialist staff.
SimonsVoss Technologies AG is not liable for any damage caused by incorrect
programming.
An incorrectly programmed or faulty Q3007 can block access via a door. SimonsVoss
AG is not liable for the consequences of such an occurrence, such as blocked access
to persons who are injured or in danger, material damage or any other damage.
1.2 Product description
The Q3007 differs from normal transponders by the fact that
it is also equipped with a highly sensitive Atmel Fingerprint
Sensor. In just a few seconds, a high-powered processor in
the transponder compares the saved fingerprint with the
fingerprint read in by the sensor. In this way, only people
whose fingerprints have been scanned in already can use
the transponder. This guarantees maximum security against
unauthorised use by third parties, e.g. if the transponder is
unsupervised, or is lost or stolen. The Q3007 is therefore
particularly suitable for applications where a transponder is
provided with very many or very specific authorisations, e.g. if one person has a
general transponder for all doors or access to high-security areas.