Unit installation

Smart Output Module
Page 4
1.0 Important Information
 Installation of a SimonsVoss Smart Output Module requires knowledge in the
areas of approvals for electronic and electrical installation and in the use of
SimonsVoss software and the SimonsVoss System 3060. For this reason,
only trained and expert personnel should install the unit.
SimonsVoss Technologies AG will not accept any liability for damages caused by
incorrect installation.
 Incorrectly installed Smart Output Modules may block an entrance or opening.
SimonsVoss AG is not liable for the consequences of incorrect installation,
such as blocked access to injured or endangered persons, property damage
or other damages.
 Should products from other manufacturers be driven with a Smart Output
Module, the guarantee and installation conditions given by the respective
manufacturer of these devices must be observed.
 Should the maximum permissible currents (see Technical Data) be exceeded
at the outputs or should the maximum voltages be exceeded at the inputs of
the Smart Output Module, the result can be damage to the module.
2.0 Product Description
The Smart Output Module is a product that provides eight floating relay outputs,
which can be driven via a single Smart Relay, type SREL.ADV. Depending on the
transponder ID, one or more outputs can be switched for some programmable time.
This assignment (profile) can be selected as needed. This means that the Smart
Output Module is suitable, for example, for implementing an authorisation-dependent
elevator controller or a driver for opening lockers. Should more than eight outputs be
required, up to 16 modules can be connected to one type SREL.ADV Smart Relay.