Unit installation

ManualsBrandsSimons Voss Technologies ManualsGadgetsPalm LDB Version 1.40

121

122

123

124

125

126

127

128

129

130

Digital Half Cylinder

Page 11

6.5 Installation Behind Blanks for Half Cylinders With 2 Setscrews

(Old Flange Mounting)

6.5.1 Removal of the Knob and Flange of the Half Cylinder

1. Firmly hold the knob and remove the locknut on the back of the knob from the

knob with the special tool for half cylinders.

2. Use an authorised transponder to couple the cylinder and then unscrew the

knob. While doing this, you must firmly hold the catch with your hand if the half

cylinder is not installed. If the half cylinder is installed, the catch is held by the

stop within the lock.

3. Carefully pull the cable out of the socket-contact in the electronics but do not

remove the insulation sleeving. The electronic covering is thermally welded on

and also remains on the unit.

4. Remove the two Allen screws that are parallel to the battery from the flange

with an Allen key (1.5 mm). Remove the electronics module.

5. Remove the setscrew on the outer circumference of the flange (same Allen

key). Note: If you can see 3 setscrews here, this cylinder has a new flange

mounting (in this case, refer to Point 6.4)

6. The fore-part of the pipe, which sticks out of the profile, contains two slots on

which you can position the special tool (offset 90° to the lengthwise slot which

guides the cable). The narrow end of the installation tool can move into this

slot. This ensures that the pipe cannot twist.

7. Now you can unscrew the flange without the pipe also turning.

8. Remove the locknut.

9. Now you can install the blank.

6.5.2 Installing the Knob and Flange of the Half Cylinder

1. Put on the locknut. The flat surface with the bore holes faces away from the

door.

Note: If you cannot see any screw thread on the end of the pipe, this cylinder

has a new flange mounting (refer to Point 6.4).

2. Please note the two lateral impressions on opposite sides of the pipe. The

lateral setscrews of the flange must fit into this later in order to guarantee that

slot for positioning of the

special tool

setscrew

pipe

locknut

flange

electronics module

knob