Unit installation

Manual – Digital locking cylinder 3061
Page 28
10. Accessories
10.1 Knobs
The following special knobs are available as accessories:
• External knob in a TN3 design
• External knob 42 mm diameter with grip recesses
• Internal knob 36 mm diameter for .TS cylinders
• External knob shortened
• Brass knob matt (internal and external knobs)
These knobs can be used to replace the original locking cylinder knobs at any time. For
knob installation see chapter 5 (installation instructions) or chapter 7 (battery change).
10.2 Core protection adapter set
A mechanical extension is available for core protection hardware as the profiles on
these is not machined out. The extension is 8 mm in length and be retrofitted at any
time.
10.3 Tools
An assembly/battery tool is supplied in addition to the installation tools. This tool is
used to assemble and disassemble the external knobs and to replace batteries.
10.4 Battery set
Battery packs are available to order. This set contains 10 batteries of type CR2450.
Please only use batteries approved by SimonsVoss.