Unit installation

Manual – Digital locking cylinder 3061
Page 20
5.4 Installing the anti-panic cylinder (Type .AP)
5.4.1 Remove internal knob
Loosen the inner knob's threaded pin (see illustration in chapter 5.4) with an
Allen key (but do not unscrew it completely). Hold the actuator and then
screw off the internal knob in an anti-clockwise direction, or pull the knob
from freely rotating .AP cylinders after loosening the threaded pin.
5.4.2 Securing the digital cylinder in the lock
First turn the actuator until it is vertical and pointing downwards.
Push the digital locking cylinder through the lock from the outside so that the
external knob (see illustration in chapter 5.4) is facing towards the outside of
the door. Secure the locking cylinder in the slot-in lock with the fixing screw.
& Do not strike or hit the knobs under any circumstances during
installation. The cylinder must not come into contact with oil, paint or
acids.
Internal knob
Recessed grip ring
External knob
Assembly/battery
tool