Manual


Figure 1: Removing the combination tool from the buttstock well
2) Remove the cleaning rod (Figure 2). Rotate the bayonet away from the fore end, draw
the head of the cleaning rod away from the barrel and pull it upward. Rotate the bayonet
down and snap it back into its folded position. 

Figure 2: Removing the cleaning rod
3) Remove the receiver cover (Figure 3). Hold the carbine in the left hand behind the
small of the stock. Rotate the receiver cover pin upward with the fingers of the right hand
and, pressing with the thumb of the left hand on the cover (moving it slightly forward),
pull the pin to the right as far as it will go. Remove the cover from the receiver.

Figure 3: Removing the receiver cover
4) Remove the recoil mechanism. Grasp it in the right hand and pull it from the channel
in the bolt carrier. 
5) Remove the bolt assembly (Figure 4). Holding the carbine with the left hand at the fore
end, with the right hand draw the bolt assembly back by the handle; rotate the carbine
with the right side down and remove the bolt carrier along with the bolt housing.

Figure 4: Removing the bolt assembly from the receiver
6) Separate the bolt housing from the bolt carrier, holding the bolt carrier. 