Manual

weakening the pressure, remove the hammer spring plunger from the circular-shaped
collar of the automatic sear and trigger. Remove the hammer spring from the plunger. 


Figure 11: Removing the hammer
7) Disassemble the recoil mechanism (Figure 12). Place the guide tube over the head of
the cleaning rod and rest the cleaning rod on a table or object. Compress the recoil spring
and remove the collar. Remove the spring from the guide tube and shaft; take the
cleaning rod out of the tube, and then drop the guide rod out of the tube.

Figure 12: Disassembling the recoil mechanism
8) Separate the firing pin and extractor from the bolt housing. Drive the dowel out of the
bolt housing with the drift and a hammer (Figure 13). Remove the firing pin, push the
extractor back and upward with finger pressure, and remove it from the bolt housing
(Figure 14). Remove the extractor spring from the extractor slot by rotating it
counterclockwise.

Note:
In early issue bolts, remove the extractor, draw out the extractor spring, drive out the pin, remove the
firing pin with spring, then remove the spring from the firing pin.
