Manual

Collecting and Shooting the SKS Rifle

4) Remove the extractor.

Reassembly Instructions

5) Snap the extractor back onto bolt

body.

6) Make sure the extractor channel is

positioned as shown in figure 6.

7) Reinsert the firing pin. Make certain

that the firing pin is positioned inside

the bolt so you can slide the firing pin

retaining pin into the bolt body.

8) Insert the firing pin retaining pin.

9) Using the blunt side of a punch,

lightly tap the firing pin retaining pin

so it is completely seated.

http://www.surplusrifle.com/sks/boltdisassemble/index.asp (3 of 3) [11/8/2002 8:19:40 PM]