Manual

Note: It may be necessary to pry the receiver cover pin handle away 1;onl
the receiver before it can be rotated.
Remove the rcceivcr cover to the rear and pull the driving spring
assembly out of the bolt carrier.
(4) Open the magazine by pulling the magazine catch
(fig 3 ) to the rear. Pull the operating handle fully rearward, and
lift the bolt carrier and bolt out of the receiver. Separate the bolt
from the bolt carrier.
(5) Rotate the gas cylinder tube lock (fig 2 ) to its
uppermost position and lift the rear of the handguard to remove
the gas cylinder tube and the gas piston. The tube can be upended
and the piston will slide out.
Figure 7 .
SKS field stripped.
(6) If necessary,
the trigger group can be removed by
dcprcssing the catch located behind the loop of the trigger guard
and pulling the trigger group down and out of the rifle. The safety
must be in the safe position before the catch can be depressed.
(7) No further disassembly is necessary or desirable.
7