S1800 Electric Pressure Washer Use and Care Guide 039-8561-6 Congratulations on the purchase of your new pressure washer. In order to ensure you have the best possible experience please read through the following instruction. If you require any help please contact the customer service department at: 1-866-4SIMONIZ (1-866-474-6664) Contact us for assistance, we’re here to help. Model no. VE05 Version no.
Table of Contents 1. IMPORTANT PRECAUTIONS ................................................................................................................................3 1.1 DEFINITIONS ...........................................................................................................................................................3 1.2 SAFETY WARNINGS .................................................................................................................................................
Important Precautions 3 1. IMPORTANT PRECAUTIONS IMPORTANT, RETAIN FOR FUTURE REFERENCE AND READ CAREFULLY! Do not attempt to install or operate this device until you have read the safety instructions in this manual. Safety items throughout this manual are labelled with Danger, Warning, or Caution depending on the risk type. 1.1 Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Important Precautions 1. IMPORTANT PRECAUTIONS (CONT.) 1.2 Safety Warnings (cont.) WARNING - INJECTION HAZARD • Equipment can cause serious injury if the spray penetrates the skin. Do not point the gun at anyone or any part of the body. In case of penetration, seek medical aid immediately. CAUTION - DETERGENTS • This device has been designed for use with detergents that are specifically approved for pressure washer use.
Important Precautions / Safety Features and Electrical Information 5 1. IMPORTANT PRECAUTIONS (CONT.) 2.1 Extension Cords 1.3 Intended Application This product is designed for specific residential applications. Do If possible, do not use extension cords with this product. However, not modify or use this product for any application other than if you must use one, observe all warnings and instructions listed the one it was designed for. This equipment was not designed below: for industrial use.
Explosion View / Parts List 3. EXPLOSION VIEW D A E F G B H I C J 4. PARTS LIST Item # A B C D E Part Name Up-handle assembly Handle lock Detergent bottle & cap Tips kit (3 tips & turbo) Quick-connect wand Qty. Illustration / Part # 1 VE05-030-0000 2 VE05-030-0002 1 VE05-050-0000 1 set VE05-031-0000 1 XE05-000-0003 Item # Part Name F Gun assembly Cleaning G needle *H Hand crank High-pressure *I hose *J Water filter Qty.
Assembly Instructions 7 5. ASSEMBLY INSTRUCTIONS 5.1 Surface Preparation Before beginning any cleaning task, it is important to inspect the area for objects that could create a hazard. Remove any objects from the work area that could be tripped over, such as toys or outdoor furniture. Ensure that all doors and windows are closed tightly. 5.4 Assembly Steps A 5.2 Water Supply (Cold Water Only) Only draw water through the unit. The device must be used with cold water supply only.
Assembly Instructions 5. ASSEMBLY INSTRUCTIONS (cont.) 5.4 Assembly Steps (cont.) F D 1 2 D4 D1 D2 3 (When using detergent) 1. Fill the detergent container with detergent. 2. Firmly close the detergent bottle cap. 3. Attach the container to the pressure washer’s container storage area. D3 G Attach the desired spray tip to the wand. The spray tips (D) are for the following purposes: • D1 (Red - 0º): For tough spots and grimes (e.g.
Assembly Instructions 9 5. ASSEMBLY INSTRUCTIONS (cont.) 5.4 Assembly Steps (cont.) K H Attach garden hose to water supply and turn water on. J Plug the unit into an outlet. WARNING Make sure the main switch is in the OFF position. Plug the unit into an outlet. Make sure your hands are dry. OFF (0) L Make sure the main switch is in OFF position. Release the safety trigger if it is locked.
Assembly Instructions 5. ASSEMBLY INSTRUCTIONS (cont.) 5.4 Assembly Steps (cont.) Ä PURGING Ö ON (1) Turn the main switch to ON position and the pressure washer is ready to operate. Purge air by squeezing the trigger on the gun until there is a steady stream of water. CAUTION Drain unit after each use (for storage): remove water connection, turn ON the machine for a few seconds and press gun trigger to bleed remaining water in the pump. Turn OFF immediately.
Operating Instructions 11 6. OPERATING INSTRUCTIONS 6.1 Working with Detergents d Working with a detergent ensures quick soaking of the dirt, and allows the high-pressure water to penetrate and remove the dirt more effectively. Always spray detergent on a dry surface, do not pre-soak the area. Wetting the surface first dilutes the detergent and reduces its cleaning ability. 1 To apply detergents, you must be operating at a low pressure.
Operating Instructions 6. OPERATING INSTRUCTIONS (cont.) 6.2 Shutting Down and Cleaning Up a s (Skip this step if you are not using detergent.) When you finish using the detergent injection system, fill the detergent container with clean water. Siphon water at a low pressure for one minute, so that all detergent is flushed through the system. Remove the detergent container and rinse it thoroughly. Turn off water supply and disconnect the garden hose from the water inlet on the pressure washer.
Winterizing and Long-Term Storage 13 7. WINTERIZING AND LONG-TERM STORAGE 7.1 Optimum Winterizing Procedure Winterizing your pressure washer will help protect and prolong its life. We strongly recommend you follow the below steps using Pressure Washer Antifreeze (039-8602-0). This will keep the internal parts lubricated, protected from rust, and prevents the pump from freezing. 1. 2. 3. 4. Connect the pump saver to the inlet adaptor. Depress button on top of Pump Saver container.
Cleaning and Maintenance / Technical Specifications 8. CLEANING AND MAINTENANCE 8.1 Connections 8.3 Water Filter Screen The connections on the pressure washer’s hoses, gun, and spray wand should be cleaned and lubricated with non-water soluble grease regularly. 8.2 Spray Tips (Excluding Turbo Tip) Clogging of the nozzle causes the pump pressure to be too high, making it necessary to clean the nozzle immediately.
Troubleshooting 15 10. TROUBLESHOOTING Disconnect the device from the power source before making any repairs. Problem Cause Solution The motor does not start. The On/Off switch is in the OFF position. The power cord is not plugged in. The extension cord is too long. The extension cord is not the proper gauge. The extension cord is damaged. The power outlet does not supply adequate power. Tripped pressure washer circuit breaker. The garden hose is too small. Turn the switch to the ON position.
Troubleshooting 10. TROUBLESHOOTING (cont.) Problem Cause The garden hose Loose fittings. connection leaks. Missing/worn rubber washer. Spray wand, The spray nozzle extension, or was not properly nozzle leaks. attached. The pump is noisy. Water leaks from the pump (up to 10 drops per minute is permissible). Oil is dripping. Motor hums but fails to run. Solution Problem Tighten fittings. Insert new washer. Motor hums but fails to run (continued). Ensure the quickconnect wand is attached securely.
Limited Warranty 17 11. LIMITED WARRANTY Always keep your receipt as proof of purchase. We’re here to help! If you have any questions or comments, call our toll-free hotline 1-866-4SIMONIZ (1-866-474-6664). Have your serial number ready. The serial number can be found on the back plate, located on the side of the unit. This product has a Parts Replacement, Product Exchange and/or Repair Warranty only. NO REFUNDS will be provided. Please see stores for Product Exchange details.
