Instruction manual

8
Water Supply (Cold Water Only)
• Do not draw non-water liquids through the
unit. For use with cold water supply
only.
• Water hose must be at least a 1/2”
in diameter.
• Flow rate of water supply must not fall below
2GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
• The water supply temperature must not
exceed 40°C (104°F).
ASSEMBLY AND OPERATING INSTRUCTIONS
Step 1
Insert handle frame into pressure washer and align
holes. Insert three nuts into the front, and screws
from behind as shown in Fig.1. Tighten screws.
Step 2
Assemble the gun supporter.
Step 3 (First time use only)
Remove and discard the covers. Separate quick-
connect coupler assembly. Attach quick-connec-
tor to inlet and attach coupler onto garden hose.
 Caution 
• Never use the pressure washer to draw
in water contaminated with solvents
(e.g. paint thinners, gasoline, oil, etc.).
• Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
checking the water filter (located inside
the water inlet; to clean it out see
Maintenance section).
• Always prevent debris from being
drawn into the unit by using a clean
water source and an accessory water
filter if required.
Step 4
Attach high-pressure hose (using the end with
the O-ring) into the high-pressure outlet, and
hand-tighten the threaded nut.
Fig.1 Fig.2
Fig.4Fig.3