Owner`s manual

7 8
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Water hose must
be at least 1/2” (13 mm) in diameter. Flow rate of water supply must not fall below 2
GPM (gallons per minute) [7.6 LPM (litres per minute)]. Flow rate can be determined by
running the water for one minute into an empty 5-gallon (19 L) container. The water supply
temperature must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking
the water (located inside the water inlet. To clean it out, see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of
use.
ASSEMBLY AND OPERATING INSTRUCTIONS ASSEMBLY AND OPERATING INSTRUCTIONS
Attach the desired colour coded spray tip to wand. Ensure it is clicked in securely. Insert the
wand into the gun. Hand tighten only.
Connect the garden hose to the inlet adapter.
Red
0°
For tough spots
& grimes (e.g.
concrete surface)
Yellow
15°
To clean larger areas
(e.g. driveway)
White
40°
For delicate cleaning
and detailing
(e.g. vehicles)
Black
Low pressure
To apply
detergent
5
1
Attach the hand crank onto the hose reel.
Attach the high-pressure hose from the hose reel to the
gun (hand tighten only).
Assemble the gun holster and cord bracket.
2
3
Recommendation for
spray tip usage:
4
Turbo spray tip
To clean larger areas
(e.g. driveway)