Users Manual

1) Connect the original power adapter with
the transmitter and an electrical outlet, slide
the OFF/ON switch to ON to power on the
transmitter.
7. Charge the Speaker
2) Put the speaker on the transmitter in
correct direction. The red charging indicator
on the speaker lights up and the speaker starts
charging.
Plug in
to
charge
Fig 7-1
c
h
a
r
g
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
A: Through the Transmitter Base
B: Through the Supplied AC Adapter
Plug the supplied AC adapter into a standard
electrical outlet, plug the other end
of the AC adapter into the port labeled “DC
9V” on the back of the speaker.
Fig 7-2
TROUBLE SHOOTING
Part 1
Set it to PCM. For example: Settings >
Sound >Digital Audio Out Format >
Dolby/DTS/PCM, select PCM. Menu
depends on TVs.
The transmitter is not
connected well.
Make sure the connection is correct and
in place between the transmitter and the
audio source.
Turn on the audio sources, and adjust
their volume to a sufficient level.
Connection between the
transmitter and audio
source is wrong.
SOLUTIONSPHENOMENA
Make sure the AC adapter and the audio
cable of the transmitter are plugged well.
CAUSES
The audio sources (TV and TV
related AV devices) are not turned
on or their volume are set too low.
Properly fully
the battery, or firmly connect the adapter.
load the battery, charge
The battery is not
loaded in the battery chamber,
the battery is run out or the
adapter is not connected firmly.
properly
Speaker receiver
doesn't work,
no sound when
used as a
wireless speaker.
TV audio output is disable or not
activated.
Follow the TV manual to change the
TV’s AUDIO OUT setting to “External
TV Speaker”.
The TV and TV related AV
device’s digital audio out format
is not set to PCM when do optical
connection.
The analog audio cable is
plugged into the AUDIO IN jack
of the transmitter when
connecting with the optical cable.
Unplug the analog audio cable from the
transmitter.
TV volume is turned down to
ZERO.
Adjust the TV volume to a sufficient
level. If you want to mute the TV, please
click the MUTE key on the TV remote
control or go to TV settings to OFF the
Internal TV speaker.
SM-621D
SM-621D
With the AUDIO IN jack at the rear of the receiver for connecting to an audio
device like PC, MP3, Mobile Phone, iPad, etc, you can turn this receiver into
a wired speaker.
3.5mm
Audio Cable
Ø
PC, MP3,
Mobile Phone,
iPad, etc
AUDIO IN
AUDIO OUT
or
Headphone
Fig 6-2
Notes: The charging time is approx. 3 hours. The will last approx 6
hours on a full charge, but will last a lesser or greater amount of time depending
on the average volume level of the speaker.
speaker
16
17
Fig 6-1
AUDIO OUT
TV
6.2 How to Use the Receiver as a Wired Speaker