User manual

SRP9170 and SRP9180 ~ PMR Portable Radio User Manual

7. SPECIAL FUNCTION KEYS

This section lists Functions that may be programmed to the F1, F2, F3, F4, F5, or F6 keys.

Selected functions may also be programmed into the 3 Position Function Switch.

Consult your Simoco Dealer for which functions have been programmed in to your radio.

7.1 MONITOR

Opens/Closes the audio (signalling) mute.

Only valid on Non-Community Repeater type channels and/or Closed Selcall channels without

Receiver Lock-out programmed.

7.2 SQUELCH DEFEAT

Opens/Closes the squelch (carrier) mute.

7.3 RESET

Closes the audio (signalling) mute on closed Selcall Channels.

7.4 SEND-2

Sends a specific Selcall sequence.

7.5 TRANSPOND

Enables/Disables Individual Call Acknowledge.

7.6 CTCSS

Defeats the CTCSS mute on the channel.

Only valid on Non-Community Repeater type channels and/or Open Selcall channels.

7.7 MUTE

Provides direct access to the Mute Setup Screen (refer to Section 6.1.2) and allows the user to

change the mute level from that screen.

7.8 GOTO CHAN A, B, C, D

Selects predefined Channel A, B, C or D, and (may) return on the second press.

The Defined Channel may be redefined if held for approximately 2 seconds.

7.9 SPECIAL ENC 1…8

Sends Special Encode 1, 2, …, 8.

7.10 ALARM

Put the portable into Alarm mode.

7.11 REPEATER DEFEAT (TALKAROUND)

Allows the radio to transmit on the reverse frequency on a Repeater Channel.

When the key is pressed again (or the Channel is changed) the transmit frequency reverts to the

original setting.

7.12 LOW POWER

Forces the radio to low power.

Pressing again puts the radio back to the power level defined for the current channel. This is not

affected by Channel changes.