User manual

SRP9170 and SRP9180 ~ PMR Portable Radio User Manual
© ComGroup Australia 2010 page 13 TNM-U-E-0089 Issue 1.4a
The
▼/▲keys are used to change the channels from the channel screen. The portable’s
selection switch may also be used to change channels.
The
Keypad may also be used to enter numbers directly, which temporarily appear on the
Message Line (overwriting the Channel Name), e.g. Changing channels from the keypad can
be done by entering the channel number and pressing the # key.
Note: If DTMF is enabled then pressing keypad keys will send the corresponding DTMF tone
whilst the PTT is pressed.
4.2 PHONEBOOK SCREEN
The Phonebook lists the Radio Users and their Selcall
codes. Selcall Identity information is stored for various
users and calls can be sent from this Screen.
The
▼/▲ keys scroll through the Phonebook entries.
Pressing the
OK key will place a call to the displayed identity.
Alternatively, if the Identity Number is known, the
Keypad can be used to enter the number,
which is sent when the
OK key is pressed (whilst in the Phonebook Screen).
The
F6 key (when configured for Reset, or any other key configured for Reset) will backspace
through keypad-entered numbers, or it will exit back to the Idle Screen if no keypad-entered
numbers remain on screen.
The
Back key returns you to the Menu Select Screen.
Refer to section 4.2 for details on Phonebook sub-menus.
Notes: 1. If the Selcall requires a Status to be included then the Saved-Status-Value will be
used (see description of Status below).
2. The Identity shown on the display when this Screen is exited may be referenced
from other Menu Screens and is called the Current-Phonebook-Entry.
4.3 STATUS SCREEN
The Status Screen is used to send short pre-programmed messages, e.g. “at lunch”, “job
complete” and so on.
The Selcall Status is selected here and can be sent from
this Screen.
The
▼/▲ keys scroll through the Status List entries.
Pressing the
OK key will send the displayed Status to the Current-Phonebook-Entry.
Alternatively, if the Status Number is known, the
Keypad can be used to enter the number,
which is sent (to the Current-Phonebook-Entry) when the
OK key is pressed.
The
F6 key (when configured for Reset, or any other key configured for Reset) will backspace
through keypad-entered numbers, or it will exit back to the Channel Select Screen if no keypad
entered numbers remain on screen.
The
Back key returns you to the Menu Select Screen.
Notes: 1. When a Status is sent, it becomes the current Saved-Status-Value, and can be
used at a later time from other Menu Screens.