Service manual

D.4 TP0332/2
Installation Warnings
Warnings that could occur during installation are shown in Table D.2.
Table D.17 Installation Warnings
Initialization File
The initialization file,
mapalign.ini
, initializes certain settings at start-up:
(1) The PC’s Serial Port used for communications with Radio [Default is COM1].
(2) Baud rate at which communication with Radio take place through the serial link [Default is 19200]
These settings can be modified using the Alignment tool via Environment in the Options menu.
See Contents in the Help menu for further information (see section Using On-line Help).
GETTING STARTED
Once the Alignment Tool has been installed, it can be run.
Starting the Alignment Tool
To start the Alignment Tool:
(1) Start Windows
(2) Activate the item ‘SRP80 Series Alignment Tool’ in the SRP80 Series Tools program group (do this
by double clicking on the icon).
A dialogue is displayed showing the Part and Version Number of the Alignment Tool. After a delay,
the Alignment Tool application window is displayed.
Errors on Starting the Alignment Tool
When the Alignment Tool is started the following types of error messages may be displayed:
Table D.18 Starting Errors
Warning Stage Occurring Action to Take
Lack of Disk
Space
After installation drive and directory
have been selected
Free at least 10Mb of hard disk space
before continuing with installation
File In Use When installation or Windows
System files are being updated
Close any Windows applications that are
running, except Program Manager.
Error Message Cause Action to Take
Could not find
initialization file
The file
mapalign.ini
was not found in
the directory of the Alignment Tool
application. It may have been renamed
or moved to another directory.
No action required. A new, default
*.ini
file is created automatically in the
directory of the Alignment Tool
application.
Initialization file
contains invalid
settings
The setting values in mapalign.ini were
not recognized.
Acknowledge the information dialogue
showing details of invalid settings–
default.ini file settings will then be used
for that session. Correct the settings in
mapalign.ini
.
Display not
compatible
The display resolution is less than the
minimum 640 x 480 pixels (width x
height).
Change the display driver to a resolution
of at least 640 x 480 (see Display
Settings on page D.6).