Service manual

TP0332/2 4.3
Figure 4.3 Removing the Metal Screen
Remove the Radio PCB
(Refer to Figure 4.4)
(1) Release the remaining flexi-circuit from the radio PCB as follows:
(a) Slide out the locking drawer of the PCB connector, SK6, (on the radio PCB). Use a very small
flat bladed screwdriver.
(b) Remove the flexi-circuit from the connector, SK6.
(2) The PCB is held in place by a leaf spring near the top of the unit (on the hidden side of the PCB).
(a) Release the PCB from the frame by gentle leverage, with a small flat bladed screwdriver, at
the slots provided either side of the frame.
(b) Withdraw the PCB from the frame taking great care not to damage the PCB or
flexi-circuit.
Caution: The PA module is a tight fit in the frame and may require easing at alternate edges of
the PCB to remove it. DO NOT attempt to remove the PCB by levering anywhere
other than at the slots provided - (2)(a) Figure 4.4.
(c) Store the PCB in a safe place until required.
Figure 4.4 Removing the Radio PCB
(1)
(2)
(1)
(1)
(1)
(1)
(1)
(1)
(1)
(2)(b)
(2)(a)
(2)(a)