Service manual

2 TP0332/2
AMENDMENT LIST
Changes made to the equipment described in this publication are published as amendments which
are dated and consecutively numbered.
Reprints will incorporate all amendments, and applicable change notes and service bulletins to date
and entries to this effect will be recorded on the amendment list below.
Each page affected by amendment action will bear the amendment number as a suffix to the
reference number, eg. TP0123/1AM4 indicates that the page has been corrected by amendment
number 4.
The text content of the page that has been affected by the amendment will be indicated by a marker
in the outside margin, starting on the first line and ending on the last line of text affected. This paragraph is
marked as an example.
Amendment packs, where applicable, can be obtained from the Order Desk.
Should it become necessary to raise the issue of a publication, the amendment numbering will
recommence with No. 1.
ERRORS AND OMISSIONS
The usefulness of this publication depends upon its accuracy. Whilst every endeavour has been
made to eliminate errors, some may exist. It is requested therefore that any errors or omissions noted be
advised as follows:
Please quote: Please send to:
(1) Title of publication Simoco Europe Ltd,
(2) TP Ref No Technical Publications Department,
(3) Last amendment No. received. P.O. Box 24,
(4) Page and/or Figure No. in error. St Andrews Road,
Cambridge, CB4 1DP,
England.
Amendment No Date Initials Remarks
July 1998
July 1998
Change Notes up to 25 June 98 actioned in this issue.
Service Bulletins up to 17 July 98 actioned in this issue.