Service manual

2.6 TP0332/2
LED
A tri-colour LED is used to indicate the status of the radio.
Table 2.1 Tri-colour LED Indications
Channel LEDs (SRP8010 only)
Figure 2.8 SRP8010 LEDs
The four channel LEDs indicate the SRP8010 receive and transmit modes (refer to Table 2.2).
Table 2.2 SRP8010 Channel LED Indications
Status LED
Transceiver initializing at
switch-on
Steady Red
Error State Steady Red
Recoverable Switch-on Error Red for 2 seconds
Switch-on (no error) Green for 2 seconds
Transmit Steady Red
Busy Flashing Yellow (0,5s on, 0,5s off)
Called Flashing Green (0,5s on, 0,5s off)
Low Battery Flashing Red (0,5s on, 0,5s off)
Transmitting with Low Battery Flashing Red (0,2s on, 0,2s off)
Status Channel LED Indication
Receive mode but no signal The appropriate LED flashes.
Receive mode with signal The appropriate LED is on continuously.
Transmit mode The appropriate LED is on continuously.
1234
Channel 4
Channel 3
Channel 2
Channel 1
Tri-colour LED