Service manual

2.4 TP0332/2
Fitting a Battery
Figure 2.5 Fitting a Battery
(1) Locate the battery on the back of the radio with approximately 10mm of the nickel plated metal
casting showing.
(2) Slide the battery up the radio. When the battery is fully in position, the catch will locate and lock.
(Refer to Remove the Battery on page 4.1 for instructions on removing the battery).
LCD DISPLAY
Figure 2.6 LCD Display
The SRP8010 variant does not have an LCD display.
An example of the LCD display is shown in Figure 2.6. The following paragraphs detail the normal
configuration of symbols. Refer to the appropriate Operating Instructions for the use of flags on particular
radios.
17 x 7 Matrix
This section is used to indicate the condition, eg. channel number or error messages, etc. - refer to
Figure 2.7.
(1)
(2)
12 Alphanumeric Characters
Signal Strength
Open Channel Indicator
Message Indicator Battery Level
17 x 7 Matrix