Service manual

TP0332/2 2.3
The antenna supplied with the radio is the correct length for the frequency band ordered and must
be fitted to the mounting boss at the top of the radio (refer to Figure 2.3 step 3).
As an option, an uncut antenna may be supplied which will cover a wide frequency band. In this
case, the antenna must be cut to the transmitter centre frequency of the frequency band to be used.
Proceed as follows:
(1) Using a suitable hacksaw or cutters, cut the antenna to the length required for the transmitter centre
frequency on which the radio is to be used, as shown on the cutting chart supplied (refer to
Figure 2.3).
(2) Fit the antenna end-cap provided, securing with cyanoacrylate adhesive.
(3) Fit the antenna.
Note: Where the antenna cutting chart shows a cut length that is longer than the uncut
length of the antenna supplied, then the antenna should be left uncut.
Fitting the Wrist Lanyard
Figure 2.4 Fitting the Wrist Lanyard
If purchased, the optional wrist lanyard is fitted as follows:
(1) Remove the antenna (if already fitted).
(2) Locate and hold the metal ring onto the antenna boss.
(3) Refit the antenna through the metal ring.