Operating instructions

SRM9030 ~ Trunk Mobile Radio User Guide
TNM-U-E-0004
Page 5 © Simoco Europe 2001
1. INTRODUCTION
The SRM9000 Series Radios are versatile Digital Signal Processor (DSP)
controlled, two-way mobile radios. The SRM9000 Series is available in a
number of frequency bands and versions for specific applications. This
manual describes the operation of the SRM9030 Trunk Alphanumeric
Display variant.
The radio consists of a Transceiver unit that may be mounted in the vehicle
boot or under a seat, and an Alphanumeric Control Unit which is designed
to mount on the vehicle console or within view and reach of the driver. A
microphone and speaker connected to the radio provide the audio interface.
The radio is software programmable and it can be customised to the
operational requirements of your particular fleet. Your Simoco
representative can help in programming your radios facilities to meet your
present and future requirements.
This guide describes the facilities that are currently available and can be
programmed into the SRM9030.
1.1 I
NSTALLATION
The SRM9030 Mobile Transceiver can be installed and set up for use by
your dealer. As the installation is a technical and possibly hazardous
operation, we do not recommend that you do it yourself. However, if you
need information regarding the correct procedures for installation, please
refer to the SRM9030 Installation Sheet supplied with the radio.
1.2 I
N THE
E
VENT OF
D
IFFICULTY
If the radio fails to switch on, check that:
•
the fuse has not blown,
Your dealer should advise you of the location of the fuse,
•
the power supply cables and connections are secure, and
•
the vehicle battery is charged.
If these checks are OK, contact your dealer for further advice.