Operating instructions

SRM9030 ~ PMR Mobile Radio User Guide

5.5.1 Scan Screen

The display shows the name of the current Scan-Group (e.g. “Scan RSE”),

which can be changed using the Left/Right Arrow buttons. The Scan-Group

Number is shown at the top-left of the display, i.e. 1…4 if it is a User Scan-

Group, or blank for Fixed Scan-Groups. While the Scan Screen is displayed

the radio is scanning the shown group.

The Scan Screen does not time-out. Normal exit is via Exit.

The RSSI indicator shows the received signal strength as the radio is

scanning.

The Function button has the same assignment as in the Main Channel

Screen.

The (Orange button) and F6 (on Microphone) are both still active.

The , and buttons are reassigned as shown.

When stopped on a channel, the Message-Line shows the name of the

selected site, and the “rotating arrow” symbol is replaced by the Speaker

symbol.

Skip temporarily deletes the channel from the Scan-Group. Skip is only

shown when stopped on a channel and the Microphone is in Cradle. Skipped

channels are restored when a different Scan Group is selected or if Scan is

exited. The Priority Channel cannot be skipped.

“Edit” is only shown for User Scan Groups and opens up the Scan-Edit Screen

for the selected Scan-Group allowing Channels to be added, deleted or set as

the priority channel (see below).

While listening on the channel, the User can PTT on that channel. After the

signal disappears (or Microphone is placed back in Cradle) the radio will

remain listening on the channel for a short time before resuming scanning.

The Microphone needs to be in cradle for the radio to scan. If the Microphone

is left off-cradle for too long then the radio will sound a continuous alert tone

until it is replaced.

If the radio is not stopped on a channel (and no Priority channel is defined)

when the Mic is removed from Cradle, then the channel shown on the display

prior to “Scan” being activated is selected.

DTMF (if enabled) is only active when the Mic is out of cradle.

The Up/Down Scroll Buttons allow access to the other Screens (not Main

Channel Screen). When these other menus time out they return to the Scan

Screen.

The Keypad may NOT be used for quick channel change (e.g. 456#) in this

Screen.