Operating instructions

SRM9020plus ~ PMR Operating Instructions

3.7 S

CAN

UNCTIONS

Scanning consists of sequentially searching up to 15 channels for a valid

signal (RF+CTCSS tone). When found, the radio will stop on that channel until

the signal disappears again.

If a Priority Channel is assigned, the radio will interleave a check of this

channel between each normal channel check. The radio may also check the

Priority Channel every few seconds while stopped on a channel. If a signal is

found on the Priority Channel then the radio will switch to that channel

immediately.

If programmed, the Priority Channel is automatically selected when the

Microphone is removed from cradle.

If scanning is enabled on your radio, press the

button from the Main Channel

Screen to enter Scan Mode, or select a channel that has been programmed as

a scan channel..

3.7.1 Scan Screen

The display shows the name of the current Scan-Group (e.g. “West”), which can

be changed using the buttons. The Scan-Group Number is shown next to

the Icon (e.g. 1) if it is a User Scan-Group, or blank for Fixed Scan-Groups.

(User Scan Groups can be edited by the User).

The Scan Screen does not time-out.

Press the S button to exit to the Main Channel screen.

Whilst listening on the channel, the User may PTT on that channel. After the

signal disappears, or the Microphone is placed back on the Cradle, the radio

will remain listening on the channel for a short time before resuming scanning.

If the radio is not stopped on a channel, and no Priority channel is defined,

when the Mic is removed from Cradle, the channel shown on the display prior to

“Scan” being activated is selected.

Scanning channels

in selected Group

Receiving

Busy

General Icons

Group Name (4 Characters)

User Group Number