Operating instructions

SRM9020plus ~ PMR Operating Instructions

3.3 V

OLUME

DJUSTMENT

The Volume Up/Down buttons set the

speech level at the loudspeaker.

Use the Up/Down buttons to set the volume

of the received signal to the required level.

When there is no signal a beep will be emitted at each button press to indicate

the volume level. During a call the beeps are omitted.

Note: The radio may be programmed so that the volume cannot be turned

off completely.

3.4 R

ECEIVING

The radio will listen on the displayed Channel. Typical Icons are:

Indicates that a valid signal is present and can be heard from the

loudspeaker.

Indicates that a signal with invalid CTCSS (or Selcall) is present and

that the speaker is muted.

The rotating bar indicates that the radio is searching the displayed

Group.

Displayed when the radio is not receiving and an entry exists in the

Stored Calls Screen.

Changing channels can be achieved by the following:

• Pressing the

buttons.

• Pressing a Go-to-Channel Function Button, refer to Section 7.10.

Note: If the displayed channel is a Vote Group, the Group name is displayed

with a rotating bar icon (when the radio is searching). When stopped

on a channel the Rotating Arrow disappears and the selected Channel

Name replaces the Group name.