Operating instructions

SRM9020plus ~ Trunked Operating Instructions
© Comgroup Australia 2010 Page 22 TNM-U-E-0085 Issue 1.0b
6. OPTIONS
The following options are available; contact your dealer for further information.
6.1 Q UICK R ELEASE T RANSCEIVER K IT
This kit provides a mounting cradle to allow the Transceiver to be quickly removed
without having to undo unnecessary screws. P/N MA-QRCRADLE
6.2 M ICROPHONE /C ONTROL H EAD E XTENSION L EAD
This lead allows the Transceiver to be placed up to 4.5 metres from the Control
Head. P/N MA-MICEXTEND
6.3 C ONTROL U NIT E XTENSION K IT
This kit allows the Transcevier to be operated up to 100 metres from the Control
Head. P/N MA-CUEXTEND
6.4 H ANDSFREE O PTION
This allows a driver to use the radio without having to lift the microphone or press
any buttons. P/N MA-HF9030
6.5 DMAP O PTION B OARD
This option board provides eight I/O lines, two serial ports and pre/de-emphasised
audio to allow external interfacing to the radio. Applications such as dual control
heads, single control head for two radios and vehicle repeater are supported by
this board. P/N MA-DMAP
6.6 GPS / A UDIO S ERIAL I NTERFACE
This provides Global Position reporting for Trunk and PMR applications as well as
a serial interface for radio control and an audio interface. P/N MA-ASIG (no GPS
fitted) P/N MA-ASIGF (GPS fitted).
6.7 C ROSS - LINKED C ABLE
This is used with various applications to cross-connect or interconnect
Transceivers or Control Heads. P/N MA-XLCABLE
6.8 600 O HM I NTERFACE O PTION
This provides a balanced 600 Ohm, 2/4 wires audio interface and opto-isolated E
and M lines. P/N MA-SIXOHM
6.9 D ESK T OP B ASE K IT
This provides a housing for the radio and incorporates an 8 Amp Power Supply
Unit and speaker. P/N MA-DESKBASE30