User's Manual

SDB680 – INSTALLATION GUIDE TNM-I-E-0046
May 15 Page 43 CONFIGURATION TIER III – TIER II
17.1. On the Upload to Base(s) page, carry out the following:
17.1.1. Select the base you wish to upload the software to.
17.1.2. Select the ‘Upload’ button to programme the base with the Application Software and
the Cerebral Platform.
17.2. On the DMR Tier II ribbon bar, select the Re-boot button. The Re-boot Base(s) page will be
displayed.
17.3. On the Re-boot Base(s) page, select the base station that the software was uploaded to and
select the ‘Re-boot’ button. The base station will re-boot and load the new versions of
software.
17.4. Create a working configuration that includes the new DMR Base in accordance with the
SDMT User Manual [2] and appropriate for the system in which it is installed.
17.5. On the DMR Tier II ribbon bar, select the ‘Write’ button. The ‘Write Base(s)’ page will be
displayed and any open base configuration pages will be closed.
17.6. On the ‘Write Base(s)’ page, carry out the following:
17.6.1. Select the new DMR Base that is included in the working configuration.
17.6.2. Select the ‘Write’ button. A progress bar will briefly be displayed.
17.6.3. After a few seconds, check that a green dot appears in the Success column for the
selected base (indicating that the Write operation has been successful) and a ‘Reboot’
button appears at the bottom of the page.
Note.
To complete the software configuration update procedure for the selected DMR Base, the base must
be re-booted.
17.6.4. Select the Reboot button to enable the base to use the new configuration.