Manualshelf

User's Manual

ManualsBrandsSimoco EMEA ManualsElectronicsLandmobile UHF Base Station
21222324252627282930
SDB680 – INSTALLATION GUIDE TNM-I-E-0046
May 15 Page 23 WALL MOUNT INSTALLATION
Figure 5. Keyhole Standoff mounting locations.
Figure 6. Base Station secured to Wall Mount.
1.3
E
LECTRICAL
C
ONNECTIONS
12. Refer to the Electrical Connections section, for full details of all connections and the connector pin-
outs.
13. Using a suitable test set, e.g. an Anritsu/Wiltron S331A, check the Tx and Rx antenna connections for
a VSWR of 1.5:1 or better at the relevant Tx and Rx Frequencies.
14. On the SDB680 Base Station rear panel, carry out the following:
14.1. Connect the Tx and Rx antenna cables to their respective connectors.
14.2. Ensuring that the power source is switched off, connect the DC power cable from the ‘DC IN’
connector to the power source.
15. Carry out the configuration of the SDB680 in accordance with
Section 3 – Configuration of New
Tier II Base Station or Section 4 – Configuration of New Tier III Base Station as appropriate.