User's Manual

SDB680 – INSTALLATION GUIDE TNM-I-E-0046
Aug 14 Page 37 CONFIGURATION TIER II – TIER III
13.7.1. On the Upload to Base(s) page, select the ‘Browse’ button for the Application
Software File. An Open file dialogue window will be displayed.
14. On the ‘Open’ file window, navigate to and select the latest version of the DMR Tier III
Application Software downloaded at Para 10. Select the Open button to load the file into the
SDMT.
15. On the SDMT main screen, on the Upload to Base(s) page, select the ‘Browse’ button for the
Cerebral Platform File. An Open file dialogue window will be displayed.
16. On the ‘Open’ file window, navigate to and select the latest version of the DMR Tier III
Cerebral Platform software downloaded at Para 10. Select the Open button to load the file
into the SDMT.
17. On the SDMT main screen, carry out the following:
17.1. On the Upload to Base(s) page, carry out the following:
17.1.1. Select the base(s) you wish to upload the software to.
17.1.2. Select the ‘Upload’ button to programme the base with the Application
Software and the Cerebral Platform.
17.2. On the DMR Tier II ribbon bar, select the Re-boot button. The Re-boot Base(s) page
will be displayed.
17.3. On the Re-boot Base(s) page, select the base station(s) that the software was
uploaded to and select the ‘Re-boot’ button. The base station(s) will re-boot and load
the new versions of software.
5.4.2 Tier III IP Address Configuration
18. On the IP Configuration Tool, in the data grid of the main screen, select the relevant MAC
Address for the Tier II Base.
19. Refer to the Simoco IP Configuration Tool User Manual [3] and configure a Tier III IP
Address for the relevant MAC Address listed in the data grid of the main screen in
accordance with Section 2.2 – Configuring an IP Address. Ensure that the ‘System’,
‘VAC’, ‘Site’ and ‘Base’ details entered are relevant to the Tier III system.
Note.
When configuring the IP address for the Tier III base station, the Tier III ‘System’
number entered above must match the system number that the Tier III base station is
to be added to. Refer to Para 12 above and Para 2.3 of Section 2.2 – Configuring an IP
Address in the Simoco IP Configuration Tool User Manual [3] for clarification.
5.4.3 Software Licence Update
20. On the SDMT main screen, on the ribbon bar, select the DMR Tier III tab.
20.1. On the DMR Tier III ribbon bar, select the System Commands button. The System
I/O configuration page will be displayed.
20.2. On the System I/O page, in the System Monitor area, expand the navigation tree and
check that the new Tier III base has been added to the system.
20.3. On the System I/O page, select the ‘Browse’ button for the Licence file. An Open file
dialogue window will be displayed.