User's Manual

SDB680 – INSTALLATION GUIDE TNM-I-E-0046
Aug 14 Page 34 CONFIGURATION TIER III BASE
28.2. In the Comms History area, confirm that a ‘Starting Write All Config’ message is
displayed.
28.3. The progress of the write operation will be displayed in the ‘Current Message
Progress’ area.
28.4. In the Comms History area, after a short delay, confirm that a ‘Completed Write All
Config’ message is displayed.
28.5. When the write operation is completed, the success or failure of the operation for
each VAC, Site or Base will be indicated in the Comms History area.
4.6.4 Enable Bases
29. On the system I/O page, in the System Monitor area, on the navigation tree, carry out the
following:
29.1. To enable all the bases on a system, carry out the following:
29.1.1. Right click on the VAC that you wish to enable. Menu options will be
displayed.
29.1.2. From the menu options, select ‘Site Options’ > ‘Enable Site(s)’. The sites
enable warning message will be displayed.
29.2. To enable an individual base, carry out the following:
29.2.1. Right click on the Base that you wish to enable. Menu options will be
displayed.
29.2.2. From the menu options, select ‘Base Operations’ > ‘Enable Base(s)’. The
base enable warning message will be displayed.
29.3. On the relevant warning message, select ‘Yes’ to continue.
29.4. In the System Monitor area, on the navigation tree, confirm that the status notification
that was alongside the relevant VAC, Site or individual base has now disappeared.
29.5. In the Comms History area, after a short delay, confirm that the relevant ‘Completed
Enabling Base’ message(s) is displayed.