User Manual

SGD-SB2025NT-TUM, Part 2
Jan 12 Page 14 INTRO TO ET
Figure 1. ET window – Status Bar.
1.3.1 Default Setting
If this is the first usage of an ET application, there will be no default settings, otherwise the settings
will be those used on the last occasion taking information held in an “ini” configuration file. If this
file is not found, it will be automatically created in the same folder as that holding the application
itself. As long as future ET software application releases are placed in that same folder, the
original “ini” file will be recognised and previously selected options will be used.
Figure 2. ET opening window.
1.3.2 Com Port
If there is a need to change the Com port setting, then proceed as follows:
1. On the ET window, carry out the following:
1.1. Close the ‘Disconnected’ sub-window.
1.2. From the menu bar select Options > Setup (see Figure 3 below). The ‘ET Setup’
window will be displayed.
Figure 3. Options Menu.