User Manual

SGD-SB2025NT-TUM, Part 2
Jan 12 Page 37 SOLAR CONFIGURATION
Figure 25. Allocating a Station NI.
The allocation process is as follows:
1. On the TM ET window, on the relevant station panel, click the “identity” button to gain access
to the ‘NI Setup’ page.
2. On the ‘NI Setup’ page, carry out the following:
2.1. Enter the ‘IP address’ of the NI that is to be used as the Station Interface for that
number.
2.2. Check the ‘Enable’ check box.
2.3. Select ‘Apply’ > ‘Close’.
3. Repeat Paras 1 to 2.3 for each Station NI on the system.
If the NI is connected to the network, communication should be established immediately so that the
NI adopts a Station mode of operation with the station panel number displayed as the system
‘Address’ on the NI main window. The station panels will also confirm communication is active by
displaying a Green status indication at the bottom of the panel (see Figure 26 below).
Figure 26. Station #1 allocated and operating.