User Manual

SGD-SB2025NT-TUM, Part 2
Jan 12 Page 34 SOLAR CONFIGURATION
2.1. Enter the IP address and subnet mask.
Note.
The subnet mask and gateway address are not required by a NI but this facility has
been provided for possible future upgrades.
2.2. Check the ‘Enable’ box.
2.3. Select ‘Apply’ and then ‘Close’.
3. Repeat Paras 1 to 2.3 above for every NI in the system.
It may prove helpful if the IP address is noted on the NI case to save having to reconnect the NI ET
later just to find that detail (it is not visible to the TM ET).
4.3 S ETTING T HE TM IP A DDRESS (TM ET O NLY )
The next stage is to set the IP address of the TM and this requires that the TM ET is connected
locally (front panel USB connection).
Figure 23. Setting the TM IP Address.
To set the IP address of a TM, proceed as follows:
1. On the TM ET window, select the ‘TM’ tab (indicated in Figure 23 ) to open the view of the
TM status panel.
2. On the TM Status Panel, select the ‘Network’ button to open the ‘TM Network Setup’ page.
3. On the ‘TM Network Setup’ window, carry out the following:
3.1. Select the ‘Eng’ button and enter the ‘IP address’, ‘Subnet mask’ and ‘Gateway’
address.