Installation Guide

Page 4/10
Safety Data Sheet (SDS)
OSHA HazCom Standard 29 CFR 1910.1200(g) and GHS Rev 03.
Issue date 06/22/2016 Reviewed on 06/22/2016
Trade name: TekTop 100% Solvent-Free Silicone RTV
43.0
Absorb with liquid-binding material (i.e. sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to section 13.
·
Reference to other sections:
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
7 Handling and Storage
·
Handling
·
Precautions for safe handling:
Ensure good ventilation/exhaustion at the workplace.
Prevent formation of aerosols.
·
Information about protection against explosions and fires:
No special measures required.
·
Conditions for safe storage, including any incompatibilities:
·
Storage
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Keep receptacle tightly sealed.
·
Specific end use(s):
No further relevant information available.
8 Exposure Controls/Personal Protection
·
Additional information about design of technical systems:
No further data; see section 7.
·
Control parameters:
·
Components with occupational exposure limits:
The following constituent is the only constituent of the product which has a PEL, TLV or other recommended
exposure limit.
At this time, the other constituents have no known exposure limits.
1317-65-3 Calcium Carbonate
NIOSH Short-term value: 5 mg/m³
Long-term value: 10 mg/m³
NIOSH TWA Short-term value: 5 mg/m³
Long-term value: 10 mg/m³
espirable dust
OSHA Short-term value: 5 mg/m³
Long-term value: 15 mg/m³
OSHA TWA Short-term value: 5 mg/m³
Long-term value: 15 mg/m³
espirable fraction
·
Additional information:
The lists that were valid during the creation of this SDS were used as basis.
·
Exposure controls:
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed.
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing and wash before reuse.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
·
Breathing equipment:
Not required.
(Contd. on page 5)