Full Product Manual

Page 4/10
Safety Data Sheet (SDS)
OSHA HazCom Standard 29 CFR 1910.1200(g) and GHS Rev 03.
Reviewed on 03/20/2018
Issue date 03/20/2018
Trade Name: Epoxy Acrylic Roof Primer
46.1.5.2
·
Further information about storage conditions:
None.
·
Specific end use(s):
No further relevant information available.
*
8 Exposure Controls/Personal Protection
·
Additional information about design of technical systems:
No further data; see section 7.
·
Control parameters:
·
Components with occupational exposure limits:
The
following constituents are the only constituents of the product which have a PEL, TLV or other
recommended exposure limit.
At this time, the other constituents have no known exposure limits.
57-55-6 Propylene Glycol
WEEL Long-term value: 10 mg/m³
1333-86-4 Carbon black
PEL Long-term value: 3.5 mg/m³
REL Long-term value: 3.5* mg/m³
*0.1 in presence of PAHs;See Pocket Guide Apps.A+C
TLV Long-term value: 3* mg/m³
*inhalable fraction
·
Additional information:
The lis
ts that were valid during the creation of this SDS were used as basis.
·
Exposure controls:
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed.
Wash hands before breaks and at the end of work.
·
Breathing equipment:
Not required.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Select glove material based on penetration times, rates of diffusion and degradation.
·
M
aterial of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material cannot be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material:
The exact break-through time has to be determined and observed by the manufacturer of the protective
gloves.
·
Eye protection:
Goggles recommended during refilling.
(Contd. on page 5)