Specifications

9 Rev: 11/21/02
AERATOR ASSEMBLY
Fig. 2.5
2.78 Attach the sensor assembly (Fig. 2.6) with the union to the air intake pipe.
Tighten as much as possible by hand. NOTE: Be sure that the O ring seal is in
the union half of the assembly.
2.79 Tie the aerator power cord to the air intake pipe with the plastic ties. CAUTION:
Do not pull or stretch the power cord. To facilitate removal, a nylon rope or
chain can be attached to the lifting ring on the top of the aerator.
2.80 By grasping the air intake pipe, carefully lower the aerator assembly through the
center of the tank opening to the bottom. CAUTION: Be sure to keep the air
tubing from crimping which will prevent air flow.
Primary Sensor
Union
Plastic Tie
Power Cord
Impeller
1/2" Plug
Tee
Air Pipe
Aerator
Foam Cap
(Caplug)
Air Tubing
Sensor Wires