hardware design v1 00 2
Table Of Contents
- Contents
- Version History
- 1 Introduction
- 2 SIM900R Overview
- 3 Package Information
- 4 Application Interface
- 4.1 Power Supply
- 4.2 Power on/down Scenarios
- 4.3 Power Saving Mode
- 4.4 RTC Backup
- 4.5 Serial Interfaces
- 4.6 Audio Interfaces
- 4.7 SIM Card Interface
- 4.8 LCD Display/SPI Interface
- 4.9 Keypad Interface
- 4.10 ADC
- 4.11 RI Behaviours
- 4.12 Network Status Indication
- 4.13 General Purpose Input/Output (GPIO)
- 4.14 External Reset
- 4.15 PWM
- 4.16 I2C Bus
- 4.17 Antenna Interface
- 5 Electrical, Reliability and Radio Characteristics
- 5.1 Absolute Maximum Ratings
- 5.2 Recommended Operating Conditions
- 5.3 Digital Interface Characteristics
- 5.4 SIM Card Interface Characteristics
- 5.5 VDD_EXT Characteristics
- 5.6 SIM_VDD Characteristics
- 5.7 VRTC Characteristics
- 5.8 Current Consumption (VBAT = 3.8V)
- 5.9 Electro-Static Discharge
- 5.10 Radio Characteristics
- 6 Manufacturing
- Appendix
Smart Machine Smart Decision
SIM900R_Hardware Design_V1.00 30 2012-07-20
Figure 28: Molex 91228 SIM card holder
Table 9: Pin description (Molex SIM card holder)
Signal Description Pin name
SIM_VDD SIM card power supply C1
SIM_RST SIM card reset C2
SIM_CLK SIM card clock C3
GND Connect to GND C4
GND Connect to GND C5
VPP Not connect C6
SIM_DATA SIM card data I/O C7
C8 SIM_PRESENCE Detect SIM card presence
4.8 LCD Display/SPI Interface
SIM900R provides a serial LCD display interface. It could also be used as SPI interface in the embedded AT
application. For details about embedded AT application, please refer to document [7].
Note: This function is not supported in the standard firmware. If user wants this function, the firmware must be customized.
Please contact SIMCom for more details.