hardware design v1 00 2
Table Of Contents
- Contents
- Version History
- 1 Introduction
- 2 SIM900R Overview
- 3 Package Information
- 4 Application Interface
- 4.1 Power Supply
- 4.2 Power on/down Scenarios
- 4.3 Power Saving Mode
- 4.4 RTC Backup
- 4.5 Serial Interfaces
- 4.6 Audio Interfaces
- 4.7 SIM Card Interface
- 4.8 LCD Display/SPI Interface
- 4.9 Keypad Interface
- 4.10 ADC
- 4.11 RI Behaviours
- 4.12 Network Status Indication
- 4.13 General Purpose Input/Output (GPIO)
- 4.14 External Reset
- 4.15 PWM
- 4.16 I2C Bus
- 4.17 Antenna Interface
- 5 Electrical, Reliability and Radio Characteristics
- 5.1 Absolute Maximum Ratings
- 5.2 Recommended Operating Conditions
- 5.3 Digital Interface Characteristics
- 5.4 SIM Card Interface Characteristics
- 5.5 VDD_EXT Characteristics
- 5.6 SIM_VDD Characteristics
- 5.7 VRTC Characteristics
- 5.8 Current Consumption (VBAT = 3.8V)
- 5.9 Electro-Static Discharge
- 5.10 Radio Characteristics
- 6 Manufacturing
- Appendix
Smart Machine Smart Decision
4.5.2 Software Upgrade and Debug
Refer to the following figure for debugging and upgrading software.
Figure 20: Connection for software upgrading and debugging
The serial port and the debug port support the CMOS level. If user connects the module to the computer, the
level shifter should be added between the DCE and DTE.
For details about software upgrading,please refer to document [4].
4.6 Audio Interfaces
SIM900R provides one analog input, AIN, which could be used for electret microphone. The module also
provides one analog output, AOUT. The output can directly drive 32Ω receiver.
AT command “AT+CMIC” is used to adjust the input gain level of microphone. AT command “AT+SIDET” is
used to set the side-tone level. In addition, AT command “AT+CLVL” is used to adjust the output gain level. For
more details, please refer to document [1] and document [5].
In order to improve audio performance, the following reference circuits are recommended. The audio signals have
to be layout according to differential signal layout rules as shown in following figures. If user needs to use an
amplifier circuit for audio, National Semiconductor Company’s LM4890 is recommended.
4.6.1 Speaker Interface Configuration
SIM900R_Hardware Design_V1.00 25 2012-07-20
Figure 21: Speaker reference circuit