SIM8300G-M2 Hardware Design V1.01 Draft
Table Of Contents
- Contents
- Table Index
- Figure Index
- 1. Introduction
- 2. Package Information
- 3. Interface Application
- 4. Antenna Interfaces
- 5. Electrical Specifications
- 6. Appearance
- 7. Packaging
- 8. Appendix
SIM8300G-M2 Hardware Design V1.01
www.simcom.com
41
/
77
3.11 CONFIG Pins
These signals are provided to indicate its specific configuration that is WWAN-USB3.1 of SIM8300G-M2.
Table 29: CONFIG pins state of the module
Pin no.
Pin name
Description
21
CONFIG_0
Connected to ground internally
69
CONFIG_1
Connected to ground internally
75
CONFIG_2
Connected to ground internally
1
CONFIG_3
Not connected
In the M.2 specifications, the CONFIG pins are defined as below.
Table 30: CONFIG interface definition
CONFIG_0
(Pin 21)
CONFIG _1
(Pin 69)
CONFIG _2
(Pin 75)
CONFIG _3
(Pin 1)
Module type and
Main host interface
Comments
GND
GND
GND
NC
WWAN – USB 3.1
Vender defined
3.12 LED1#*
LED1# is open drain output and is used to allow SIM8300G-M2 to provide network status via LED which will
be provided by the host.
Figure 20: LED1# reference circuit