SIM8300G-M2 Hardware Design V1.01 Draft
Table Of Contents
- Contents
- Table Index
- Figure Index
- 1. Introduction
- 2. Package Information
- 3. Interface Application
- 4. Antenna Interfaces
- 5. Electrical Specifications
- 6. Appearance
- 7. Packaging
- 8. Appendix
SIM8300G-M2 Hardware Design V1.01
www.simcom.com
40
/
77
3.10 DPR*
DPR (Dynamic Power Reduction) signal is used for SAR (Specific Absorption Rate) requirements. The RF
output power would reduce if this signal is triggered by sensor under some certain conditions, such as SAR
sensor triggered, defined by customers.
User can activate this function with AT command.
Table 28: Definition of DPR# pin
Pin no.
Pin name
Pin status
Function
25
DPR
Low
Max transmitting power will be reduced by set through AT
command
High
Max transmitting power will not be reduced (default)
Floating
Max transmitting power will not be reduced
“*” means under development.
NOTE