Sim800 hardware design v1.05
Table Of Contents
- Version History
- 1. Introduction
- 2. SIM800 Overview
- 3. Package Information
- 4. Application Interface
- 4.1. Power Supply
- 4.2. Power on/down SIM800
- 4.3. Power Saving Mode
- 4.4. RTC Backup
- 4.5. Serial Port and USB Interface
- 4.6. RI Behaviors
- 4.7. Audio Interfaces
- 4.8. Bluetooth
- 4.9. SIM Card Interface
- 4.10. PCM Interface
- 4.11. Keypad Interface
- 4.12. I2C BUS
- 4.13. General Purpose Input/Output (GPIO)
- 4.14. ADC
- 4.15. PWM
- 4.16. Network Status Indication
- 4.17. Operating Status Indication
- 4.18. KPLED
- 4.19. RF Synchronization Signal
- 4.20. Antenna Interface
- 5. PCB Layout
- 6. Electrical, Reliability and Radio Characteristics
- 6.1 Absolute Maximum Ratings
- 6.2 Recommended Operating Conditions
- 6.3 Digital Interface Characteristics
- 6.4 SIM Card Interface Characteristics
- 6.5 SIM_VDD Characteristics
- 6.6 VDD_EXT Characteristics
- 6.7 VRTC Characteristics
- 6.8 Current Consumption (VBAT=4V)
- 6.9 Electro-Static Discharge
- 6.10 Radio Characteristics
- 6.11 Module RF Receive Sensitivity
- 6.12 Module Operating Frequencies
- 7. Manufacturing
- 8. Appendix
Smart Machine Smart Decision
Figure 44: Reference circuit of NETLIGHT
4.17. Operating Status Indication
The STATUS pin indicates the operating status of module. The pin output high when module power on, output
is low when module powered off.
Table 34: Pin definition of the STATUS
Pin name Pin number Description
STATUS 66
Operating status indication
SIM800_Hardware Design_V1.05 50 2014-03-25
4.18. KPLED
SIM800 provides one open-drain LED driver pin.
Table 35: Pin definition of the KPLED
Pin name Pin number Description
KPLED 23 Sink current for keypad LED
Reference circuit is recommended in the following figure:
KPLED
VBAT
Figure 45: KPLED driver reference circuit