Hardware+Design V1.07
Table Of Contents
- Revision History
- 1 Introduction
- 2 Package Information
- 3 Application Interface Specification
- 4 RF Specification
- 5 Reliability and Operating Characteristics
- 6 Guide for Production
- Appendix
Smart Machine Smart Decision
R2
C1
60
MODULE
59
MAIN_ANT
GND
C2
58
GND
R1
Antenna feed pad
Matching circuit
J1
J2
Figure 42: Antenna matching circuit
In this figure, the components R1,C1,C2 and R2 is used for antenna matching, the value of components
can only be got after the antenna tuning, usually, they are provided by antenna vendor. By default, the R1,
R2 are 0 ohm resistors, and the C1, C2 are reserved for tuning.
The RF test connector in the figure is used for the conducted RF performance test, and should be placed as
close as to the module’s antenna pin. The traces impedance between components must be controlled in
50ohm.
SIM5320_Hardware Design_V1.07 2012-09-21
55