Users Manual Part 2

SIM8260A_Hardware Design_V1.05
www.simcom.com 120 / 122
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device
doesnotcauseharmfulinterference.
§ 15.21 Information to user.
AnyChangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldv
oid
theuser'sauthoritytooperatetheequipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against
harmful interference in a residential installation. This equipment generates uses and can
radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception,
which can bedetermined byturning the equipment off and on,the user is encouraged to try to
correctthe
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Body-worn Operation
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated withmini mum distance 20cm between the
radiator &
your body
C.Appendix A
A1.Requirement of FCC KDB 996369 D03 for module certification:
1.1List of applicable FCC rules:
ThemodulecomplieswithFCCPart22,24,27,90,96
1.2Summarizethespecificoperationaluseconditions
1.3Limited module procedures: