Users Manual Part 1

SIM8260A_Hardware Design_V1.05
www.simcom.com 4 / 122
SIM83X0X_Series_Hardware Design
2.Add SIM8360A, SIM8380A and SIM8280A information
3.change table 6: about ANT Pin Frequency Range
4.change Table 13 Power on timing and electronic
characteristic and add note
5.change chapter 3.8 about (u)SIM socket model
6.add chapter 3.21 about mmW interface
7.add chapter 6.7 about baking conditions
Shaoxu Hou
2022-09-05
1.05
1. Changed Table about mmW recommended connector
type
2. Modify Table, add SIM8380E module information
3. Modify Table, modify the main frequency of the
application processor, and add the module weight
information
4. Add lines of Ipeak (QTM) related information to the
content of Table
5. Increase the minimum output current capability
requirement of external DCDC for mmW modules
6. Add module VDD_EXT peripheral reference circuit
7. Changed the content of the PCIe switch chapter, and
changed the corresponding recommended material table
8. Add PCIe interface for IPQxxxx related content
9. Change the Codec ALC5616 special attention content
10. Supplement table content of W_DISABLE pin
description
11. Change module Figure
12. Increase the content that PCIe_RST needs to be
pulled up
13. The ID resistance of the PM7250B interface
reference circuit is changed from 100K to 200K
14. Modify the description of pin AF3(SLEEP_OUT)
15. The data transfer throughput of different modules is
changed to a table representation
16. Add the antenna port definition table of SIM8380E
17. Modify the Ipeak,Ton (STATUS)value
18. Change the description of module pin D9
19. Added chip junction temperature table in thermal
design chapter
Shaoxu Hou
Zhongxi Xiang