Specifications

FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this
device does not cause harmful interference.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help. Body-worn Operation
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated withmini mum distance 20cm
between the radiator & your body
This Modular Approval is limited to OEM installation for mobile and fixed applications
only. The antenna installation and operating configurations of this Modular, including any
applicable source-based time averaging duty factor, antenna gain and cable loss must satisfy MPE
categorical Exclusion Requirements of 2.1091.
if the host is marketed so that end users do not have straight forward commonly used methods for
access to remove the module so that the FCC ID of the module is visible; then an additional
permanent label referring to the enclosed module: Contains Transmitter Module FCC ID:
2AJYU-8XM0001 or Contains FCC ID: 2AJYU-8XM0001 must be used.