User's Manual
Table Of Contents
- Contents
- Table Index
- Figure Index
- 1Introduction
- 1.1Product Outline
- 1.2Hardware Interface Overview
- 1.3Hardware Block Diagram
- 1.4Functional Overview
- 2Package Information
- 2.1.Pin Assignment Overview
- 2.2.Pin Description
- 2.3.Mechanical Information
- 2.4.Footprint Recommendation
- 3Interface Application
- 3.1Power Supply
- 3.3UART Interface
- 3.4USB Interface
- 3.5SIM Interface
- 3.6PCM Interface
- 3.7I2C Interface
- 3.8SPI Interface
- 3.9Network status
- 3.10ADC interface
- 3.11LDO output
- 3.12USB_BOOT Interface
- 3.13GPIO Interface
- 3.14 RF control Interface
- 3.15Force USB Download Interface
- 4RF Specifications
- 4.1LTE RF Specifications
- 4.2LTE Antenna Design Guide
- 4.3GNSS
- 4.4RF traces note
- 5 Electrical Specifications
- 5.1Absolute maximum ratings
- 5.2Operating conditions
- 5.3Operating Mode
- 5.4Current Consumption
- 5.5ESD Notes
- 6 SMT Production Guide
- 6.1Top and Bottom View of SIM7090G
- 6.2Label Information
- 6.3Typical SMT Reflow Profile
- 6.5Baking
- 6.6Stencil Foil Design Recommendation
- 7 Packaging
- 7.1Tray packaging
- 8 Appendix
- 8.1Coding Schemes and Maximum Net Data Rates over Air
- 8.2Related Documents
- 8.3Terms and Abbreviations
- 8.4Safety Caution
SIM7090G User Manual V1.01
www.simcom.com 53 / 77
Avoiding the paroling rout of other system antennas nearly.
There should be some distance from The GND to the inner conductor of the SMA connector. It is
better to keep out all the layers from inner to the outer conductor.
Figure 29: The distance between GND to the inner conductor of SMA
GND pads around the ANT pad should not be hot pad to keep the GND complete.
4.4.2 LTE ANT and other system ANT decoupling
Make sure the efficiency of LTE main ANT more than 40%
Keep the decoupling of LTE main ANT to WLAN ANT more than 15dB
Keep the decoupling of LTE main ANT to GNSS ANT more than 30dB
The decoupling value can be provided by ANT adventure. More details can refer to the document [22].
NOTE