Specifications

SIM6600-M2 Hardware Design V1.00
www.simcom.com
16
/
54
of UIM interface
should be
protected against
ESD.
If unused,please
keep open.
resistor to UIM1_PWR.
UIM1_CLK 32
P4 DO UIM1 clock signal.
UIM1_RESET 30
P4 DO UIM1 Reset control.
UIM1 DET 66 P3 DI UIM1 card detect.
UIM2_PWR 48
PO
Power supply for UIM2
card.
UIM2_DATA 42 P4
UIM2 Card data I/O, which
no need reserve Pull up
resistor to UIM2_PWR.
UIM2_CLK 44 P4 UIM2 clock signal.
UIM2_RESET 46
P4 UIM2 Reset control.
UIM2_DET 40
P4 UIM2 card detect.
Antenna control interface*
ANTCTL0 59 P3 DO Antenna tuner control 0
1.8V voltage
domain.
If unused, please
keep open.
ANTCTL1 61
P3 DO Antenna tuner control 1
ANTCTL2 63
P3 DO Antenna tuner control 2
ANTCTL3 65 P3 DO Antenna tuner control 3
MIPI_DATA 58 P3 DIO
MIPI interface tunable
ANT,
MIPI data
MIPI_CLK 56
P3 DO
MIPI interface tunable
ANT,
MIPI clock
MIPI_1V8 24
P3 PO
1.8V power output for
antenna tuner
I2S interface*
I2S_CLK 20 P3 DI I2S serial clock,Reserved
1.8V voltage
domain.
If unused, keep
them open.
I2S_RX 22 P3 DO
I2S Serial receive
data,Reserved
I2S_TX/ANT_TUNER_C
FG
50 P3 DO
I2S Serial transmit
data,can mux as
ANT_TUNER_CFG or
GPIO,reserved
I2S_WS 52 P3 DO
I2S word
alignment/select,Reserved
I2S_MCLK 60 P3 DO I2S main clock,Reserved
I2C interface
I2C_SDA 68
P3 DIO
I2C data signal
1.8V voltage
domain.Internal
pulled up to 1.8V.
If unused, please
keep open.
I2C_SCL 38 P3 DO I2C clock signal
I2C_IRQ# 54
P3 DI
I2C interrupt request,can
mux as GPIO
UART interface
UART_RXD 62 P3
UART receive data,can
mux as GPIO.
1.8V voltage
domain.
UART_TXD 64 P3
UART transmit data,can
mux as GPIO.
Other pins
LED1# 10 OD The module