User's Manual

7. Label and compliance information
An exterior label on OEM’s end product can use wording such as the following:
“Contains Transmitter Module FCC ID: 2AJYU-8PYA009 ” or “
Contains FCC ID: 2AJYU-8PYA009 ”
8. Information on test modes and additional testing requirements
a)
The modular transmitter has been fully tested by the module grantee on the
required number of channels,modulation types, and modes, it should not be
necessary for the host installer to re-test all the available transmitter modes or
settings. It is recommended that the host product manufacturer, installing the
modular transmitter,perform some investigative measurements to confirm that the
resulting composite system does not exceed the spurious emissions limits or band
edge limits (e.g., where a different antenna may be causing additional emissions).
b)
The testing should check for emissions that may occur due to the intermixing of
emissions with the other transmitters, digital circuitry, or due to physical properties
of the host product (enclosure). This investigation is especially important when
integrating multiple modular transmitters where the certification is based on testing
each of them in a stand-alone configuration. It is important to note that host product
manufacturers should not assume that because the modular transmitter is certified
that they do not have any responsibility for final product compliance.
c)
If the investigation indicates a compliance concern the host product manufacturer is
obligated to mitigate the issue. Host products using a modular transmitter are
subject to all the applicable individual technical rules as well as to the general
conditions of operation in Sections 15.5, 15.15, and 15.29 to not cause
interference. The operator of the host product will be obligated to stop operating the
device until the interference have been corrected .
9.
Additional testing, Part 15 Sub part B disclaimer The final host / module
combination need to be evaluated against the FCC Part 15B criteria for
unintentional radiators in order to be properly authorized for operation as a Part 15
digital device.
Smart Machine Smart Decision
Antenna type:
External fixed
omni antenna
2500-2570 MHz(TX)
2620-2690 MHz(RX)
Peak Gain
11.50dBi
6.
Antenna